![]() ![]() Complete the following in order to Install the thermostat into the thermostat housing:Īlign the thermostat pin to the thermostat housing orifice.Pull the thermostat from the thermostat housing. Release the pressure from the thermostat. Rotate the thermostat until it clears the retaining feature of the housing. Complete the following in order to remove the thermostat from the thermostat housing:ĭepress the ears on both sides of the thermostat.Refer to Engine Coolant Thermostat Housing Replacement. It is in the rear of the engine by the firewall and the intake manifold will need to be removed to gain access t it.Įngine Coolant Thermostat Replacement (LA3, LY9) Where is thermostat located on 2005 Dodge Thermostat Replacement on Toyota Corolla? Replacing thermostat on 1999 Mercury Cougar? How to replace thermostat on 1992 Buick century? How to locate Thermostat on Any car model? How to replace Radiator on Audi and VW car Where is thermostat located on 2006 dodge THERMOSTAT REMOVAL PROCEDURE/LOCATION DETAILS Pull the thermostat out of the intake manifold.įor more help and troubleshooting go through the help links below:. Loosen the hose clamp on the manifold end of the hose and remove the hose. Trace the upper radiator hose to the mounting area on the intake manifold. Hope helps (remember rated this) Good luck. Connect the negative (-) battery cable.Install the upper radiator hose, close the draincock and refill the cooling system.If removed, install the exhaust air induction tube clamp bolts.Install the water outlet and tighten the bolts.That the spring is toward the inside of the engine. When installing the thermostat, be sure to install a new gasketĪnd be sure the air bleed hole in the thermostat is facing upward and.Torque should be checked again after RTV has completely dried. TheĬomponent MUST be tightened before the RTV dries completely. Allow the RTV to dry slightly to form a thin skin. When using RTV sealant instead of gaskets, make sure the surface youĪre working on is very clean before applying the sealant, then apply anĮven bead. Clean off the old gasket from the mating surfaces of the thermostat housing and engine block.Remove the water outlet and thermostat.Remove the bolts securing the water outlet to the cylinder head and any Remove the upper radiator hose from the water outlet side and.When cool, open the draincock on the radiator and drain the coolant into a suitable drain pan.Disconnect the negative (-) battery cable.The water outlet casting attached to the water pump. On the GA16DE engines, the thermostat is housed in The thermostat is housed in the water outlet casting on the cylinder
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |